00 Dodge Ram Van Remote Fob Entry Setup
The Dodge Ram Van (2000) can ONLY have 2 remotes
1. Turn ignition to OFF.
2. Locate the Data Link Connector, its a black 16 pin connecter that is
under the driver’s side dash, right where your right knee would be.
You have to look up into the dash from below to see it.
3. Ground pin 1 of the Data Link Connector by taking a wire or paper clip
and running it from pin 1 to pin 4. Pin 4 is ground so you can just short
pin 1 to 4 and it will be grounded. Grounding pin 1 tells the system you
are ready to reprogram it.
4. Close all of your doors.
5. Turn the key to ACC then back off. The power door locks will
lock/unlock. This is the signal that the system is ready for reprogramming.
6. Push a button on your key fob, doesn’t matter which button.
7. If you have 2 key fobs, then press a button on the 2nd fob within 1minute
of pressing a button on the 1st fob. Both must be programmed at the
same time. If you only have 1 fob then press a button 2 more times to signal
that you only have one.
8. The doors will lock/unlock to signal the codes were received.
9. Remove the jumper wire from the data connector.”
10. turn key off