10-13 Cadillac SRX Control and Immobilizer Procedures
Program remote transmitter when added, replaced or on system malfunction
How – Without Smart entry system
- Remote transmitter can only be programmed using diagnostic equipment
NOTE: Existing remote transmitter memory positions will be overwritten
- Obtain and reprogram all remote transmitters
- NOTE: A maximum of 8 remote transmitters can be programmed
How – With Smart entry system and one programmed remote transmitter available
- NOTE: A maximum of 8 remote transmitters can be programmed
- Obtain all remote transmitters
- NOTE: Switch ignition OFF
- Place all programmed remote transmitters within in the cup holder
- Insert key of the unrecognized remote transmitter into driver’s door lock
- Turn key to unlock position 5 times within 10 seconds
- Driver’s information center will display READY TO LEARN ELECTRONIC KEY #2, 3, or 4, etc
- Place the new, unrecognized remote transmitter into the center console remote transmitter pocket with remote transmitter button facing down and key ring at the rear
- Press and release the ignition switch. Driver’s information center will display READY FOR FOB X
- Remove remote transmitter from remote transmitter pocket and press remote transmitter UNLOCK button
- Repeat above procedure starting with placing the next unrecognized remote transmitter into the remote transmitter pocket until all remote transmitters have been programmed
NOTE: To exit programming mode press the OFF/ACC button (ignition switch) for 15 seconds.
How – With Smart entry system and no programmed remote transmitter available
- Obtain all remote transmitters
- Note: Switch ignition OFF
- Insert key of unrecognized remote transmitter into driver’s door lock
- Turn key to unlock position 5 times within 10 seconds
- Driver’s information center will display REMOTE LEARN PENDING, PLEASE WAIT
- After 10 minutes Driver’s information center will display PRESS ENGINE STARTBUTTON TO LEARN
- Press the OFF/ACC button (ignition switch)
- Driver’s information center will display REMOTE LEARN PENDING, PLEASE WAIT
- After 10 minutes Driver’s information center will display PRESS ENGINE START BUTTON TO LEARN
- Press the OFF/ACC button (ignition switch)
- Driver’s information center will display REMOTE LEARN PENDING, PLEASE WAIT
- After 10 minutes Driver’s information center will display PRESS ENGINE START BUTTON TO LEARN
- Press the OFF/ACC button (ignition switch)
- Driver’s information center will display READY FOR REMOTE #1
- Place the new, unrecognized remote transmitter into the remote transmitter pocket with remote transmitter buttons facing the front of the vehicle
- Press and release the OFF/ACC button (ignition switch). Driver’s information center will display READY FOR REMOTE # X
- Remove first remote transmitter (FOB 1) and press a button to finalize
- Carry out above procedure, starting with placing next urecognized remote transmitter into remote transmitter pocket, repeat for all remaining remote transmitters
- When allremote transmitters have been programmed driver’s information center dislays MAXIMUM # ELECTRONIC KEYS LEARNED and will exit programming mode
- Press the OFF/ACC button (ignition switch) for 10 seconds to exit programming mode
- NOTE: Remote transmitters can also be programmed using diagnostic euipment
Immobilizer
without iriginal master key
- Keys can only be programmed using diagnostic equipment
with original master key
- Insert master key into ignition switch
- Switch ignition ON
- Switch ignition OFF
- Remove master key
- Within 5 seconds insert new key and switch ignition on
- System LED will extinguish
- New key now programmed
- NOTE: A maximum of 10 keys can be programmed using the master key
with smart entry
- System operation – Arms after ignition switch is turned to LOCK/OFF
- Remote transmitter added or replaced, or system malfunction
- NOTE: Immobilizer is programmed during remote transmitter programming procedure