12-13 Buick Verano Smart Entry Programming Guide
Only program key when added or replaced or on system malfunction
Without smart entry system: Remote transmitter can only be programmed using diagnostic equipment
NOTE: Existing remote transmitter programming will be erased
- Obtain and reprogram all remote transmitterNOTE: A maximum of 8 remote transmitters can be programmed
How – with Smart entry system an done programmed remote transmitter available. NOTE: A maximum of 5 remote transmitters can be programmed
- Obtain all remote transmittersNOTE: Switch ignition OFF
- Place all programmed remote transmitters in the cup holder
- Insert key of the unrecognized remote transmitter into the driver’s door lock
- Turn key to unlock position 5 times within 10 seconds
- Driver information center will display READY FOR REMOTE $2, 3, 4, or 5
- Place the unrecognized remote transmitter into the remote transmitter pocket with buttons facing up
- Press ignition switch
- When remote transmitter is programmed, the DIC will show it is ready for next remote transmitter
- Remove remote transmitter from remote transmitter pocket and press the UNLOCK button
- To program additional remote transmitters, repeat previews steps starting with inserting next remote transmitter key into the driver’s door lockNOTE: To exit the programming mode, press and hold the ignition button for 10 seconds
NOTE: To exit the programming mode, press and hold the ignition button for 10 seconds
How – with Smart entry system and no programmed remote transmitters available
NOTE: A maximum of 5 remote transmitters can be programmed
- Obtain all remote transmittersNOTE: Switch ignition OFF
- Insert key of the unrecognized remote transmitter into the driver’s door lock
- turn key to unlock position 5 times within 10 seconds
- Driver information center will display REMOTE LEARN PENDING, PLEASE WAIT
- Wait 10 minutes until DIC displays PRESS ENGINE START BUTTON TO LEARN
- Press ignition switch
- Driver information center will display REMOTE LEARN PENDING, PLEASE WAIT
- Press ignition switch
- Driver information center will display REMOTE LEARN PENDING, PLEASE WAIT
- Wait 10 minutes until DIC display PRESSS ENGINE START BUTTON TO LEARN
- Press ignition switch
- Driver information center will display REMOTE LEARN PEDNING, PLEASE WAIT
- Wait 10 minutes until DIC displays PRESS ENGINE START BUTTON TO LEARN
- Press ignition switch
- Deriver information center will display REMOTE LEARN PENDING, PLEASE WAIT
- All previously programmed remote transmitters are now erased
- DIC will display READY FOR REMOTE #1
- Place the unrecognized remote transmitter into remote transmitter pocket with buttons facing up
- Press the ignition switch
- When remote transmitter is programmed, the DIC will show it is ready for next remote transmitter
- Remove remote transmitter from remote transmitter pocket and press the UNLOCK button
- To program additional remote transmitters, repeat preview steps starting with inserting next remote transmitters into the remote transmitter pocket
- NOTE: To exit the programming mode, press and hold teh ignition button for 10 seconds