Programming Instructions

A picture of an object with a blue background.

  • Obtain all remote transmitters
    NOTE: A maximum of 3 remote transmitters can be programmed
  • Switch ignition On
  • Proceed as follows:
    NOTE: Point remote transmitter at central locking signal control module (located behind glovebox)




    • Within 4 seconds: Press LOCK button [1] or UNLOCK button [2] of first remote transmitter.
    • Within 4 seconds: Switch ignition OFF
    • Within 4 seconds: Switch ignition ON
  • Repeat procedure above twice
  • With 4 seconds: Press LOCK button [1] or UNLOCK button [2] of first remote transmitter
  • System should now lock and unlock vehicle to indicate programming mode activated
  • Within 10 seconds:
    • Press LOCK button [1] or UNLOCK button [2] of first remote transmitter, allowing doors to lcok and unlock once
    • Pres LOCK button [1] or UNLOCK button [2] of each remaining remote transmitter to be programmed, allowing doors to lock and unlock once each remote transmitter is programmed
  • Switch ignition OFF
  • Remove key
  • Check operation of all programmed remote