95-98 Jaguar XJ Remote Programming Guide
1. Open boot lid (leave open)
2. Open driver’s door (leave open)
3. Turn ignition switch ”ON” but do not start engine.
4. Rock valet switch (located in center console) 5 times;
a single chirp and flash of the headlamps indicate the
Security Locking Control Module has entered the ”learning”
mode.
5. Press the alarm/lock (larger) button of the first transmitter.
This transmitter will be linked to position 1 of the
seat/steering/mirror memory. A tone will confirm that the
transmitter code was accepted. Note that the button must be
pushed within 15 seconds or the module will exit the ”learning”
mode.
6. Rock valet switch once. Two short chirps will indicate the
system is ready to accept a second transmitter.
Press the arm/lock (larger) button of the second transmitter.
Two tones will confirm the transmitter code was accepted.
7. Repeat steps 5 and 6 for up to a total of 5 transmitters.
The second transmitter programmed will be linked to position 2;
the third to position 3, and so forth. The number of
confirmation chirps mentioned in step 6 will indicate the
transmitter count (i.e. 3 chirps for third transmitter).
Note that you must cycle through steps 5 and 6 five times
regardless of the number of transmitters; if you have less
than 5 transmitters just repeat using the last transmitter
until 5 cycles have been finished.
8. Turn ignition off and close door and boot lid.
Test for proper operation of the seat/steering/mirror memories.