11-13 Chevy Avalanche Remote Control Programming Instructions
Program only when system malfunction, key added or replaced.
Remote alarm/central locking instructions. Remote transmitters can only be programmed using diagnostic equipment. NOTE: A maximum of 8 remote transmitters can be programmed
Immobilizer How – with original master key
- Insert master key into ignition switch
- switch ignition ON
- switch ignition OFF
- Remove master key
- Switch ignition ON
- New key now programmed
- NOTE: a maximum of 10 keys can be programmed using the master key
Immobilizer How – Without original master key without RPO 5L5
- Note: all existing vehicle keys will have to be reprogrammed using the master key
- to program a new master key proceed as follows
- Switch ignition ON with master key to be programmed
- System warning lamp or message will be displayed
- After approximately 10 minutes lamp/message will switch OFF
- Switch ignition OFF
- Wait 5 seconds
- Switch ignition ON
- Wait 5 seconds
- Switch ignition ON
- System warning lamp or message will be displayed
- After approximately 10 minutes lamp/message will switch OFF
- Switch ignition OFF
- Wait 5 seconds
- Switch ignition ON
- System warning lamp or message will be displayed
- After approximately 10 minutes lamp/message will switch OFF
- Switch ignition OFF
- Wait 5 seconds
- Start engine
- New master key now programmed
- With a scan tool, clear any digital trouble codes (DTC’s)
- Replacement parts can also be programmed using diagnostic equipment
- NOTE: Replacement keys have to be cut using ignition lock number, or using original as pattern
Immobilizer How – Without original master key – with RPO 5L5
- NOTE: All existing vehicle keys will have to be reprogrammed
- To program a new master key proceed as follows:
- Switch ignition ON with master key to be programmed
- System warning lamp or message will be displayed
- After approximately 2 minutes lamp/message will switch OFF
- Switch ignition OFF
- Wait 5 seconds
- Switch ignition ON
- System warning lamp or message will be displayed
- After approximately 2 minutes lamp/message will turn OFF
- Switch ignition OFF
- Wait 5 seconds
- Switch ignition ON
- System warning lamp or message will be displayed
- After approximately 2 minutes lamp/message will switch OFF
- Switch ignition OFF
- Wait 5 seconds
- Start engine
- New master key now programmed
- With a scan tool, clear digital trouble codes (DTC’s)
- Replacement parts can also be programmed using diagnostic equipment
- NOTE: Replacement keys have to be cut using ignition lock number, or using original as pattern.