94-99 Buick Park Avenue Programming Instruction for Keyless Entry

  1. Insert key in ignition and leave in the OFF position
  2. Locate the Data Link Port. It is located under dash drivers side. Be sure you know
    which pins are 8 and 4.
    (Note port is wider at top) Your OBDII port will not
    have numbers, use this diagram for reference. buick-lesabre-1994-1999
  3. Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a
    suitable jumper wire (leave the jumper wire connected throughout the programming
    procedure). Make sure you know which terminals are 8 and 4. The vehicle will respond
    by locking and unlocking the doors to signify entering of programming mode.
  4. Close doors.
  5. Turn ignition to the ON position (as far as you can go without cranking the engine).
    Doors will lock.
  6. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to
    be programmed. After about 15 seconds, the vehicle will respond by locking and
    unlocking the doors. Release the buttons on the transmitter.
  7. Within one minute, repeat the previous step on the remaining transmitters to be
    programmed.
  8. Remove jumper wire applied to the OBDII Port.